ÀÌÀü
ATMEGA162-16PU
´ÙÀ½
À§·Î
 
   ·Î±×ÀÎ
   
 
 
 ÇöÀçÀ§Ä¡ : HOME   > ¹ÝµµÃ¼
  > ¹ÝµµÃ¼
  > MCU£¯MPU£¯DSP
  > AVR
  > ATMEL £¯MCU
 ATMEGA162-16PU
 
 8-bit AVR Microcontroller with 16K Bytes In-System Programmable Flash
 
 
ÆǸŰ¡°Ý 7,300 ¿ø(VATÆ÷ÇÔ)
¸ðµ¨¸í ATMEGA162-16PU
Á¦Á¶¿ø ATMEL [ºê·£µå ¹Ù·Î°¡±â]
Àç°í ÆǸÅÁß
±¸¸Å¼ö·® EA  
 
Features

• High-performance, Low-power AVR? 8-bit Microcontroller
• Advanced RISC Architecture
  – 131 Powerful Instructions – Most Single-clock Cycle Execution
  – 32 x 8 General Purpose Working Registers
  – Fully Static Operation
  – Up to 16 MIPS Throughput at 16 MHz
  – On-chip 2-cycle Multiplier
• Non-volatile Program and Data Memories
  – 16K Bytes of In-System Self-programmable Flash
     Endurance: 10,000 Write/Erase Cycles
  – Optional Boot Code Section with Independent Lock Bits
     In-System Programming by On-chip Boot Program
     True Read-While-Write Operation
  – 512 Bytes EEPROM
     Endurance: 100,000 Write/Erase Cycles
  – 1K Bytes Internal SRAM
  – Up to 64K Bytes Optional External Memory Space
  – Programming Lock for Software Security
• JTAG (IEEE std. 1149.1 Compliant) Interface
  – Boundary-scan Capabilities According to the JTAG Standard
  – Extensive On-chip Debug Support
  – Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
• Peripheral Features
  – Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
  – Two 16-bit Timer/Counters with Separate Prescalers, Compare Modes, and Capture Modes
  – Real Time Counter with Separate Oscillator
  – Six PWM Channels
  – Dual Programmable Serial USARTs
  – Master/Slave SPI Serial Interface
  – Programmable Watchdog Timer with Separate On-chip Oscillator
  – On-chip Analog Comparator
• Special Microcontroller Features
  – Power-on Reset and Programmable Brown-out Detection
  – Internal Calibrated RC Oscillator
  – External and Internal Interrupt Sources
  – Five Sleep Modes: Idle, Power-save, Power-down, Standby, and Extended Standby
• I/O and Packages
  – 35 Programmable I/O Lines
  – 40-pin PDIP, 44-lead TQFP, and 44-pad MLF
• Operating Voltages
  – 1.8 - 5.5V for ATmega162V
  – 2.7 - 5.5V for ATmega162
• Speed Grades
  – 0 - 8 MHz for ATmega162V (see Figure 113 on page 265)
  – 0 - 16 MHz for ATmega162 (see Figure 114 on page 265)


• <Àý´ë ÁÖÀÇ> ¸ðµç »óÇ°Àº Á¦Ç° ºÒ·®ÀÌ ÀÖÀ» ¼öµµ ÀÖ½À´Ï´Ù. µû¶ó¼­ ¾î¶°ÇÑ °æ¿ì¿¡µµ »óÇ°°¡°Ý ÀÌ»óÀÇ º¸»óÀº ¾ø½À´Ï´Ù.
• ¸ðµç »óÇ°¿¡ ³³¶« µî, »óÇ°¿¡ º¯ÇüÀ» ÁÙ ¼ö ÀÖ´Â ¸ðµç ÀÛ¾÷ ÈÄ¿¡´Â. ºÒ·®ÀÌ ¹ß»ýÇÏ¿©µµ º¸»óÀº ¾ø½À´Ï´Ù.
• »ó±â Á¦Ç°ÀÇ »óÇ° °ü·Ã µ¥ÀÌŸ´Â Âü°í »çÇ×À̹ǷΠÁ¦Ç°¿¡ ´ëÇÑ Å×½ºÆ® ¹× Á¤È®ÇÑ ÀÚ·á È®ÀÎ ÈÄ »ç¿ëÇϽñ⠹ٶø´Ï´Ù.
• °ü·Ã µ¥ÀÌŸ¿¡ ´ëÇÑ ³»¿ë¿¡ ´ëÇØ ¹ß»ýÇÏ´Â ¹®Á¦¿¡ ´ëÇؼ­´Â ¹ýÀûÀΠåÀÓÀ» ÁöÁö ¾Ê½À´Ï´Ù.




¿¡½ºÅ©·Î ¼­ºñ½º